Re: Huntron 2000

[Tim R.]

Hello Everyone

I am hoping I can get some guidance here with this problem I am having. I started with the Huntron Guru but he has retired " congradulations to the Huntron Guru" !  I have just started so I will list what been discussed so far.

(Tim)
Happy Friday first of all. So I picked up this very clean 2000. However the CRT display is a single dot only it will not expand out. I do hope you can guide me in the right direction as to make a fix. Hopefully once repaired it will need to be recalibrated. I have read some of the posts where I can find a manual to accomplish this final task.

(Huntron Guru)
Hi Tim,
Sounds like the Tracker has no signal sweep. There coulld be several causes. Check the fuse on the signal board as it have blown.
Tracker manuals can be downloaded from the website

So i verified the fuse was good. I did a close visual inspection and the unit is very clean with nothing visually damaged or burnt or corroded. So Iam open to the next possible step. I did down load the proper manual and I am getting familiar with it.

[CWSmith]

Hi Tim,
Ohm out the range resistors on the signal board. One of them could be damaged. Hopefully you have schematics. If not, you can download the manual from the Huntron website.
This is 2000 with the gray plastic case, right?

Cheers!
CW

[Al1234]

Hi, I've never had the pleasure of working with a huntorn 2000, but had the same problem with a couple of ProTrack I 20. it was a bad and missing eprom