Recent posts

#91
Obsolete Software / Re: Huntron ProTrack I + Scann...
Last post by CyberG3N - November 01, 2023, 08:55:26 AM

I completed the Loop Calc process. I restarted Workstation. It asks me to do loop calc again.
#92
Obsolete Software / Re: Huntron ProTrack I + Scann...
Last post by CyberG3N - November 01, 2023, 08:49:20 AM
I perform Loop Calc and restart the workstation. It asks me to do loop calc again
#93
Obsolete Software / Re: Huntron ProTrack I + Scann...
Last post by admin - November 01, 2023, 08:36:02 AM
Using the software with the ProTrack requires the Loop Calc file to run. Perform the Loop Calc in the Workstation diagnostics. When done restart Workstation and try connecting to the ProTrack.
#94
Obsolete Software / Re: Huntron ProTrack I + Scann...
Last post by CyberG3N - November 01, 2023, 07:13:22 AM

I completed the installation.
The error I see now is
Hardware error
Unable to open Loop Compensation data file
Run Loop Calc in Control-Maintenance-Protrack I Diagnostics

I follow this step but I still get the same error.
#95
Obsolete Software / Re: Huntron ProTrack I + Scann...
Last post by admin - November 01, 2023, 06:09:55 AM
When you install 3.5.4 you need to do it from a simple path/directory name on the c: drive. Uninstall the software. Create a folder called "huntron" on the c: drive, unzip the downloaded file to that location then try installing.
#96
Obsolete Software / Re: Huntron ProTrack I + Scann...
Last post by CyberG3N - November 01, 2023, 03:50:36 AM
I need a detailed user manual for this device.

I downloaded Workstation 3.5.4 and installed it on Windows XP operating system, but I am getting edc1000std error.
#97
Out of Production Hardware / Re: ProTrack, meter / frequenc...
Last post by Al1234 - November 01, 2023, 12:24:24 AM
Thank you, thank you.
#98
Out of Production Hardware / Re: ProTack I 20, shows resist...
Last post by admin - October 31, 2023, 03:20:37 PM
Really big caps always so a little bit of angle.
#99
Out of Production Hardware / Re: ProTrack, meter / frequenc...
Last post by admin - October 31, 2023, 03:18:29 PM
Quote from: Al1234 on October 31, 2023, 12:09:43 PMCan a 34410A be used. **Sure.**
Also it says to connect the INPUT HI of the meter to the "Test Jack in the back of the ProTrack.
Is this the yellow jack next to the USB? **That is correct.**
#100
Out of Production Hardware / Re: ProTack I 20, shows resist...
Last post by Al1234 - October 31, 2023, 12:17:40 PM
Thank you jvthorsley, I will make the adjustments. Adjustments are those 3 potentiometer on top left?
But the signitures show a bit of leakage no?
I had to take the frequency all the way down to 30 to get this.
Ohm 20. V does not matter on cap measurements but it was on 4.