Started by Al1234, January 30, 2023, 10:44:02 PM
Quote from: Al1234 on February 01, 2023, 11:23:37 AMI will give it a try this evening but when I get to the workshop. But first I'll have to figure out what that means LOL . Thank you
Quote from: Al1234 on February 01, 2023, 01:06:34 PMOn the HS20USB board it says in the manual j402 is the serial port connection. I wired a idc 10 pin to serial as it says in the manual. connected it to a computer running xp pro sp3, 32 bit with serial port but it does not respond to any command.When I plug in the USB though it repomds to commands some and HS20USB shows under device / ports as US20JSB., but when connected though the serial port it does not show in ports or anywhere i dont think. though, computer makes a sound and Device Manager window refreshes.Maybe I'm not connecting it to the computer correctly is it connected to a national instrument serial adapter or any serial port on a computer?
Quote from: Al1234 on February 01, 2023, 07:28:36 PMOh I am carefull. I wasn't thinking about doing modification really just using the given serial port instead of the USB. And I was asking what kind of communication port was used on the non USB type Huntron Access Prober?What kind of motion control board and internal wiring diagram? Thank you Jvthorsley for the picture, but that is the out side of the chassis. It is helpful and it actually brings up new questions to mind. I need wiring diagram from inside and or some help to Connect Huntron Access Prober via serial, parallel or gpib....I do see multiple parallel connected what are they used for? one is printer what's the other one for?