Huntron Users Support Forum

Huntron User Support Forums => Current Hardware - Tracker 3200S, Tracker 2800/2800S and Access Probers => Topic started by: admin on February 28, 2017, 08:13:55 AM

Title: NEW Huntron Access RF
Post by: admin on February 28, 2017, 08:13:55 AM
Huntron has just released a new version of the Access 2 Prober called the "Access RF". It is essentially an Access 2 Prober that has been modified with high frequency cabling and custom RF probe that is connected to a Keysight 9935A Spectrum Analyzer. The system enables engineers to make precise, repeatable RF measurements on powered circuit card assemblies by placing the Langer RF probe in the same exact location each time the test is run. The Spectrum Analyzer has been integrated into the Huntron Workstation software so measurements are captured and stored to be used later for comparison. You can get more details on the Access RF web page:
http://www.huntron.com/products/accessrf.htm (http://www.huntron.com/products/accessrf.htm)
Title: Re: NEW Huntron Access RF
Post by: MichaelHeit AD7VV on September 14, 2019, 12:33:46 PM
If a person didn't have the automatic prober set up, would this combination of the Spectrum analyzer and a hand probe be useable for one off PCB testing??  Just curious.
Title: Re: NEW Huntron Access RF
Post by: admin on September 20, 2019, 07:44:49 AM
It would be supported provided the Workstation SDK is activated. Look in the Help menu under Enabled Features for activation status.