I was recently asked about using command line modifications to control Huntron Workstation startup. Listed below are those currently supported. The command line controls for Remote Control will work only if it is activated through the activation code.
Thanks.
Curtis
Command Line Parameters
Command Line Parameters are accepted for the convenience of starting the software in different modes.
MDBFilePath is the file path of the MDB board file to be opened.
SequenceName is the case sensitive name of the Sequence to be selected.
ComponentNetName is the case sensitive name pf the component or net to be selected.
/Tester - starts the software in Tester mode. The Tester pane is displayed and other items are enabled based on the setting of the Test tab in Tools->Options.
/Control - starts the software in Remote Control mode. This parameter for use with the optional Remote Control feature of the software.
/ControlNM - starts the software in Remote Control mode without minimizing the window. This parameter for use with the optional Remote Control feature of the software.
Example:
Workstation.exe "MDBFilePath" "SequenceName" "ComponentNetName" /Tester
Note: Be sure to include the "" around the parameters as shown.