Hi there!
- Which Switcher model is compatible with the Tracker 2000?
- What are the main differences between the HSR 210 and HSR 410 Switchers?
I'm going to buy a Switcher for my Tracker in question.
Thank you in advance!
I've used the 410 with 2700. When using it with 2000 I think you can connect the clock and power to it.
But, having a switches, although, manual, it's very helpfull.
I have not worked with 210 to have an oppinion on that.
But, I think 410 can be used with most instrument in order to compare...volt meters,ohm meter.....
Make sure you get it with IC clips and ribbon cables.
Hi
Your best option would be to get a Huntron DSI 700.
Run it manually or store programmes using Windows 98.
It works semi-automatically in that you have to change the ranges manually.
A cable (Clock cable) connects the DSI 700 to the Tracker 2000.
My one is getting a bit dusty through lack of use but still works.
Also attached DSI 700 clock cable details.
You might be better off saving up for a ProTrack and a scanner....it's the best thing that happend in my lab.
In fact, I ordered an HSR 410 from eBay this morning, I hope that its accessories come with it.
I'm also considering upgrading from the Tracker 2000 to a newer model such as ProTrack with a scanner.
If you don't see the leads for 410 in pictures it won't have it. I hope it does for your sake, though.
ProTrack and scanner will give you so much more option for diagnostic and testing. 24 Voltages from 0.200 to 20.....and computer connectivity with free WS 3.5 software.
When you get one, make sure it's in good shape and working.
Quote from: Al1234 on March 22, 2025, 12:13:47 PMProTrack and scanner will give you so much more option for diagnostic and testing. 24 Voltages from 0.200 to 20
It's very useful to have a test signal with 24 selectable discrete voltages from 200 mVp to 20 Vp. On the other hand, when switching from the tracker 2000 to a ProTruck I would miss the high voltage of the signal (since the voltage of the high impedance range of the Tracker 2000 is 60 Vp).
Sometimes a test signal with high voltage is required to check for an open circuit of a high impedance pin of an IC (in the case of no known good reference IC) or to examine the breakdown voltage of a TVS or a Zener diode.
Sure sure. Agreed, hi voltage is necessary.
I use a tek 577, ...etc. for hi voltage.
I can see having higher voltage on huntron though, is a plus.
I didn't know 2000 goes up to 60 v.
What do you know, You learn something every day. And that's the way I like it.
The main difference between the two is that the 210 was 20 pins and the 410 was 40 pins. Either one can be used any Tracker but are more useful if you have the power/clock cable that goes between the Switcher and the Tracker. This allows for letting the Tracker rate (ALT mode) to control the Switcher rate. If you do not have the power/clock cable, use a power adapter for the Switcher power and the Switcher's rate control.
About the High Impedance Range. You may not need the higher voltage, just the higher impedance which is available in the Trackers that do not have the higher voltage.