Huntron Support Forum

Go to Huntron web site

The Forum recently experienced a database failure with user and post information being lost.
Visit the Technical Support Announcements board for details.

  1. Huntron Support Forum
  2. All User Forums
  3. Obsolete Software
  4. WS 3.5.4 Sigassist and Sig Check button.
« previous next »
Pages: [1]

WS 3.5.4 Sigassist and Sig Check button.

  • 4 Replies
  • 9425 Views

jvthorsley

  • 205
  • Do what you do well, and if a Huntron helps use it
    • www.jhorsley.com
    • Email
WS 3.5.4 Sigassist and Sig Check button.
« on: September 27, 2012, 07:38:06 am »
I am using Workstation 3.5.4 and wonder what the difference is between Sig Check Button (Not available for ProTracks with KJ1 & KJ2 serial number prefixes.) and  Sigassist that can be activated in the Preferences menu. I find Sigassist very useful to show details of the resistive or capacitance component in a circuit.
Logged

admin

  • Huntronian
  • 400
    • HUNTRON.COM
    • Email
Re: WS 3.5.4 Sigassist and Sig Check button.
« Reply #1 on: September 27, 2012, 03:47:01 pm »
Need an assist here with locating where the Sig Check button is... (Curtis puts way back hat on...)
Logged
The most important troubleshooting tool is your eyes.

jvthorsley

  • 205
  • Do what you do well, and if a Huntron helps use it
    • www.jhorsley.com
    • Email
Re: WS 3.5.4 Sigassist and Sig Check button.
« Reply #2 on: September 27, 2012, 04:35:09 pm »
The " Sig Check Button " is mentioned on page number 121 under the heading ProTrack 1 Diagnostics in the Workstation 3.5.4 manual. It only says it checks the consistency of signatures.
« Last Edit: September 27, 2012, 04:42:42 pm by jvthorsley »
Logged

admin

  • Huntronian
  • 400
    • HUNTRON.COM
    • Email
Re: WS 3.5.4 Sigassist and Sig Check button.
« Reply #3 on: October 01, 2012, 09:04:12 am »
Ahh yes. It is part of the ProTrack Diagnostics along with Volts Check, Resistance Check, etc...
Logged
The most important troubleshooting tool is your eyes.

jvthorsley

  • 205
  • Do what you do well, and if a Huntron helps use it
    • www.jhorsley.com
    • Email
Re: WS 3.5.4 Sigassist and Sig Check button.
« Reply #4 on: October 01, 2012, 04:23:59 pm »
Yes I know its part of the ProTrack diagnostics but what does it do exactly that aparently the older ProTracks can not do. My ProTrack appears to run through all the diagnostic tests.
Any more thoughts on this Curtis??
« Last Edit: March 22, 2013, 05:42:11 pm by jvthorsley »
Logged
Pages: [1]
« previous next »
  1. Huntron Support Forum
  2. All User Forums
  3. Obsolete Software
  4. WS 3.5.4 Sigassist and Sig Check button.