Just loaded software 4.2.5513.18610.
When I am in the troublesheet pane I right click on a signature I wish to reprobe and select real time. The head will drive over and probe the correct point and I will get a new signature.
If, at this point, I right click as if to select replace signature the prober drives to the camera view in X&Y, and the probe will drive down/up an extra 2-4 times in z.
If I left select the new signature window, the prober drives to the camera view in X&Y only. Then I can right click and select replace signature with no extra probes.
Is this a new software hiccup or is there a setting that I should look at?