Huntron Support Forum

Go to Huntron web site

The Forum recently experienced a database failure with user and post information being lost.
Visit the Technical Support Announcements board for details.

NEW Huntron Access RF

admin

  • Huntronian
  • 400
    • HUNTRON.COM
    • Email
NEW Huntron Access RF
« on: February 28, 2017, 08:13:55 am »
Huntron has just released a new version of the Access 2 Prober called the "Access RF". It is essentially an Access 2 Prober that has been modified with high frequency cabling and custom RF probe that is connected to a Keysight 9935A Spectrum Analyzer. The system enables engineers to make precise, repeatable RF measurements on powered circuit card assemblies by placing the Langer RF probe in the same exact location each time the test is run. The Spectrum Analyzer has been integrated into the Huntron Workstation software so measurements are captured and stored to be used later for comparison. You can get more details on the Access RF web page:
http://www.huntron.com/products/accessrf.htm
The most important troubleshooting tool is your eyes.

MichaelHeit AD7VV

  • LT.
  • 9
  • There is only one God, and his name is Jesus.
    • Everts Air Alaska Flight Simulator Division
    • Email
Re: NEW Huntron Access RF
« Reply #1 on: September 14, 2019, 12:33:46 pm »
If a person didn't have the automatic prober set up, would this combination of the Spectrum analyzer and a hand probe be useable for one off PCB testing??  Just curious.
Michael Heit
Electronics Engineer Everts Air Alaska AD7VV

admin

  • Huntronian
  • 400
    • HUNTRON.COM
    • Email
Re: NEW Huntron Access RF
« Reply #2 on: September 20, 2019, 07:44:49 am »
It would be supported provided the Workstation SDK is activated. Look in the Help menu under Enabled Features for activation status.
The most important troubleshooting tool is your eyes.