Huntron 2800

Started by VFDTech, December 06, 2017, 07:37:41 AM

Previous topic - Next topic

VFDTech

Hello, one of my Huntron 2800 units starting loading defaults after unplugged for a few hours. Also the signatures will not work correctly until i perform a DIAG ALL option on the unit. After the unit is done with all tests it passes and works fine until the next morning. Any thoughts on this?

admin

Hi,
There is probably not much you can do to fix the problem. Contact Huntron directly for support as this sounds like a hardware problem. Make sure to include the serial number of your Tracker 2800.

Thanks.
Admin
The most important troubleshooting tool is your eyes.

VFDTech

Ok thanks, we will be sending the unit in.

jvthorsley

So has the problem been identified yet?
If its hardware sounds like a job for a ProTrack!!

admin

Turned out to be a EEPROM issue.
The most important troubleshooting tool is your eyes.