Command Line controls for Workstation startup

Started by admin, December 18, 2009, 07:53:09 AM

Previous topic - Next topic

admin

I was recently asked about using command line modifications to control Huntron Workstation startup. Listed below are those currently supported. The command line controls for Remote Control will work only if it is activated through the activation code.
Thanks.

Curtis

Command Line Parameters
Command Line Parameters are accepted for the convenience of starting the software in different modes.

MDBFilePath is the file path of the MDB board file to be opened.

SequenceName is the case sensitive name of the Sequence to be selected.

ComponentNetName is the case sensitive name pf the component or net to be selected.

/Tester - starts the software in Tester mode. The Tester pane is displayed and other items are enabled based on the setting of the Test tab in Tools->Options.

/Control  - starts the software in Remote Control mode. This parameter for use with the optional Remote Control feature of the software.


/ControlNM - starts the software in Remote Control mode without minimizing the window. This parameter for use with the optional Remote Control feature of the software.

Example:

Workstation.exe "MDBFilePath" "SequenceName" "ComponentNetName" /Tester

Note: Be sure to include the "" around the parameters as shown.
The most important troubleshooting tool is your eyes.