Hello,
I'm using an Access prober (serial, no USB) with a ProTrackI and Huntron Workstation 4 on WinXP.
Since this morning, I have some problems with align points.
When I open an existing project, when I select an align point (alignement1 or 2), the probe go to the front left end stop and do the same if I want to go to one specific pin with the Teach pane.
The other problem is, if I create a new project and want to define align points, I set the two align points, and when i click on "save" this error message appears:
Message: Input string was not in a correct format. Couldn't store <1525.98>
in AlignTop1X column. Expected type is Double.
This error occured at 11/02/2010 13:36:31
Stack: at System.Data.DataColumn.set_Item(Int32 record, Object value)
at System.Data.DataRow.set_Item(DataColumn column, Object value)
at System.Data.DataRow.set_Item(String columnName, Object value)
at Workstation.FormProber.btnAlignSave_Click(Object sender, EventArgs e)
I can't use the prober since this morning.
Thank you in advance for your help.